Rockwell-automation 2707-NP DTAM Programming Software Manual de usuario descargar pdf (Pagina 133)

A–B

Chapter

16–1

DTAM Micro

Function Key Builder

This chapter describes how to use the Function Key Builder to assign screen

selection or bit write operations to function keys (available on the DTAM

Micro only). This chapter contains these sections:

Section Page

Function Key Options 16–1

Bit Write Mode 16–2

Function Key Builder 16–3

Linking Screens to Function Keys 16–4

Assigning Bit Write Functions 16–5

You can link the DTAM Micro function keys F1 through F8 to the following

screens depending upon whether or not Auto Return is enabled.

Auto Return Enabled? Function keys can be assigned to these screen types:

Yes Data Display, Data Entry, Recipe

No Menu, Sub-Menu, Data Display, Data Entry, Security, Recipe

Pressing an assigned function key displays the function key number for

approximately 0.5 seconds and then the assigned screen. There are two

function key modes:

• Auto Return

• Continue

Auto Return

Auto return function keys return to the initial display after the linked screen

is executed. For example, assume that an application is displaying screen #6

and an auto return function key F3 is linked to a recipe screen #10. When

F3 is pressed, the recipe screen #10 is displayed. After the operator

downloads a new recipe on screen #10, the initial screen #6 is displayed.

The following table describes when the return to the initial screen occurs.

Function Key Linked To: Returns to Initial Screen After:

Data Display Screen [ ] , [PREV], or [NEXT] keys are pressed

Data Entry Screen A value is entered or

[PREV] or [NEXT] keys are pressed

➀

Recipe Screen Recipe data is downloaded or

[PREV], or [NEXT] keys are pressed ➀

➀ [PREV] and [NEXT] abort the operation.

Chapter Objectives

Function Key Options

1 2 ... 128 129 130 131 132 133 134 135 136 137 138 ... 183 184

Sin comentarios

Rockwell-automation 2707-NP DTAM Programming Software Manual de usuario Pagina 133