Rockwell-automation 2707-NP DTAM Programming Software Manual de usuario descargar pdf (Pagina 83)

Chapter 9

Creating Security Screens

9–3

You can specify up to three separate codes for each Security Screen. An

operator is allowed access by entering any of the assigned security codes.

Access is also allowed by entering the Master Security Code.

To create a security screen:

1. Select Screen Builder from the Edit File - Option Selection menu.

The Screen Builder for the main menu (screen #1) is displayed.

2. Press [F8], enter the display screen #, and select Security Screen type.

The Screen Builder for a security screen appears.

3. If no security codes have been previously defined, you are prompted to

enter a code(s).

If you are editing a screen with a previously defined security code(s), you

must press [F1] to edit the code(s).

4. Enter at least one digit at each prompt. You can enter up to eight digits.

If less than eight digits are entered, each remaining digit is displayed as a

question mark (?). The question mark is a wildcard character, designating

any character entry as acceptable.

5. To modify a security code, highlight the value and overwrite the old code.

6. To save the security code(s), press [Esc]. The cursor is then returned to

the display window where you can edit the screen text.

7. Press [Esc] to save the screen.

Creating a Security Screen

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 183 184

Sin comentarios

Rockwell-automation 2707-NP DTAM Programming Software Manual de usuario Pagina 83