Rockwell-automation 4100 ALEC AXIS LINK ENCODER CONVERTER Manual de usuario descargar pdf (Pagina 22)

Publication 4100-5.3 - June 1999

Installation & Hook-Up

See the “Setup” Chapter in this manual for instructions on setting these

switches.

The following section details how to wire the :

• AxisLink cable

• Incremental Encoder

• Registration Input

• Power connector

• Fault Relay

Wiring the ALEC

There are several connectors on the front of the ALEC. These

connectors accept the cables from AxisLink (3 pin), the Encoder (12

pin), the Registration Sensor (3 pin), the power supply (top 2 pins of

the 4 pin connector), and a Fault Relay (bottom 2 pins of the 4 pin

connector). All but the Encoder connector use flying leads to attach to

the connector. The following section details how to connect the flying

leads to the screw terminals on the plugs.

Wiring Cable Flying Leads to the Plugs

To wire the cable leads to the plug:

1. Look at the plug to make sure the terminal is open. Figure 2.2

shows both an open and a closed terminal.

Figure 2.2 Terminal diagram

Terminal open

Terminal closed

Clamping screws

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 60 61

Sin comentarios

Rockwell-automation 4100 ALEC AXIS LINK ENCODER CONVERTER Manual de usuario Pagina 22