Rockwell-automation 4100 ALEC AXIS LINK ENCODER CONVERTER Manual de usuario descargar pdf (Pagina 37)

Publication 4100-5.3 - June 1999

Setup

Extended AxisLink then the ALEC can make use of any of the settings

available on the AxisLink Address rotary switch.

Selecting the Options Configuration

Located on the front panel of the ALEC are 6 DIP switches for setting

the operating options. These six DIP switches determine the way the

ALEC operates. The DIP switches determine:

• supply voltage to the encoder

• sets extended or standard addressing nodes

• enables/disables the encoder loss fault relay

• sets extended or standard AxisLink cable length

• sets Termination 1 to extended or standard length

• sets Termination 2 to extended or standard length

Encoder Power (12V 5V)

The first DIP switch (1) sets the Encoder power to either 12V DC or

5V DC. Move the switch all the way to the left for 12 volts or all of the

way to the right for 5 volts. This setting should match the voltage

power requirement of the attached encoder.

Extended Nodes (Extd Node On/Off)

DIP Switch 2 sets the available nodes in AxisLink. If Extended Nodes

is On (switch set to left), extended AxisLink is used with 16 node

addresses available for use. If it is in the Off position (switch set to

right), standard AxisLink is used and only 8 node addresses are

available for use.

IMPORTANT

In Standard AxisLink only switch settings 0 through 7

are available for use.

ATTENTION

DIP Switch 1 must be set to the voltage power (12V or

5V) requirement of the attached encoder.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 60 61

Sin comentarios

Rockwell-automation 4100 ALEC AXIS LINK ENCODER CONVERTER Manual de usuario Pagina 37