Rockwell-automation 7000 PowerFlex Medium Voltage (B Frame) Commission Manual de usuario descargar pdf (Pagina 129)

Rockwell Automation Publication 7000-IN006B-EN-P - May 2013 125

Appendix B

Printing and Uploading Drive Data

Capturing Drive Data

You can capture and save drive data such as drive setup, parameters, variables,

trend data, fault masks, alarm queues etc., onto a laptop using the HyperTerminal

program. When using HyperTerminal to upload the data, the program prompts

you to select a file for data storage. Open a new Notepad (text) file and save that

file on the laptop before uploading data from the drive.

The following example illustrates the method to create an empty .txt file

(example1.txt) and print the data from drive to a laptop.

Required:

• Laptop with Windows HyperTerminal program

• A null-modem cable with a 9-pin female connector for the laptop serial

port, and a 9-pin male connector for the ACB Printer Port (J11). (A serial

cable with pins 2-3 swapped at one end will also work.)

1. To create an empty notepad (.txt) file, run the NotePad program (Start

>Program > Accessories > Notepad). A blank Notepad window will

appear as shown below.

Figure 68 - Opening NotePad

IMPORTANT

As of Rectifier module firmware revision 7.002G, you can record control data in

PF7000 MV ForGe Control drives using the Drive Data Recorder. This feature

captures a pre-selected set of critical control data to NVRAM whenever there is

a drive fault or there occurred any of the following warnings: Line Loss, Line

Synch Loss or Bus Transient. There is no setup or arming requirement to enable

this trending.

1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 147 148

Sin comentarios

Rockwell-automation 7000 PowerFlex Medium Voltage (B Frame) Commission Manual de usuario Pagina 129