Rockwell-automation 1609-ENET Ethernet Network Card Quick Start Manual de usuario descargar pdf (Pagina 13)

Rockwell Automation Publication 1609-QS002A-EN-P - May 2014 13

Ethernet Mode Setup Chapter 2

5. Use the PING utility to check the connection between your PC and the ENET card. From Windows, launch the

Command Prompt and enter ping 192.168.1.100. You should receive replies. Note: Make sure your computer is on

the same network as the UPS with a static IP address.

6. Open RSLinx Classic and create an Ethernet driver. Go to the Communications toolbox and select Configure

Drivers.



1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 30 31

Sin comentarios

Rockwell-automation 1609-ENET Ethernet Network Card Quick Start Manual de usuario Pagina 13