Rockwell-automation 1609-ENET Ethernet Network Card Quick Start Manual de usuario descargar pdf (Pagina 26)

26 Rockwell Automation Publication 1609-QS002A-EN-P - May 2014

Appendix B EtherNet/IP Parameters

UPS Object (0x377)

Attribute

ID Need Access Rule NV Name Data Type Description of Attribute Semantics of value

1 Required Get

NV Output Rating STRUCT of: The magnitude of the nominal output

NV VA INT VA rating

NV Voltage INT Voltage rating

NV Frequency INT Frequency rating

2 Required Get

NV Input Rating STRUCT of: The magnitude of the nominal input

NV Voltage INT Voltage rating

NV Frequency INT Frequency rating

3 Required Get NV RatingBatteryVoltage INT

The magnitude of the nominal battery

voltage rating

4Required

Get NV LowTransferVoltage STRUCT of:

The Setup of low line input voltage that allowed

the UPS system transfers to the battery source

NV UpBound INT

The maximum voltage limited for the

LowTransferVoltage

NV LowBound INT

The minimum voltage limited for the

LowTransferVoltage

Get NV HighTransferVoltage

Array of

STRUCT of:

The Setup of high line input voltage that allowed

the UPS system transfers to the battery source

NV UpBound INT

The maximum voltage limited for the

HighTransferVoltage

NV LowBound INT

The minimum voltage limited for the

HighTransferVoltage

6 Required Get NV UPS Type INT Indicate the UPS type

on-line(1)

off-line(2),

line-interactive(3),

three-phase(4),

splite-phase(5)

All other values

reserved

7 Required Get/Set NV AutoReboot INT

In backup mode, the UPS may shutdown normally

by SDA command, dry-contact remote shutdown

signal or low battery shutdown. This command is

used to determine the unit should restart or not

next time when the power restores

on(1),

off(2)

All other values

reserved

8 Required Get/Set V ShutdownAction INT

If the value is greater than 0 the UPS performs

shutdown action that defined by ShutdownType

after the seconds. 0, aborted

9 Required Get/Set V RestartAction INT

UPS will restart after the indicated number

of minutes.

-1, aborted

10 Required Get/Set NV BuzzerAlarm UINT

UPS will keep silence but will alarm again when

next power event is occurred

alarm(1),

silence(2)

11 Required Get/Set NV BuzzerState INT If it is disabled then the UPS is always muted

enable(1),

disable(2)

12 Required Get/Set NV Sensitivity INT

The sensitivity of the UPS to utility line

abnormalities or noises

normal(0),

reduced(1),

low(2)

13 Required Get/Set NV LowVoltageTransferPoint INT

The input minimum line voltage allowed before

the UPS system transfers to battery backup

14 Required Get/Set NV HighVoltageTransferPoint INT

The input maximum line voltage allowed before

the UPS system transfers to battery backup

15 Required Get/Set V ShutdownOSDelay INT

The operating system shutdown delay time when

the input power fail

16 Required Get/Set NV UPSBootDelay UINT

Delay the UPS startup after power restores.

The power quality may not stable when power

restores, this feature let the UPS wait a period

of time to startup the system

17 Required Get/Set NV ExternalBatteryPack INT Indicate the number of external battery pack

18 Required Get V InputNumLines INT The number of input lines utilized in this device Limited 1

1 2 ... 21 22 23 24 25 26 27 28 29 30 31

Comentarios a estos manuales

Sin comentarios

Rockwell-automation 1609-ENET Ethernet Network Card Quick Start Manual de usuario Pagina 26

Comentarios a estos manuales

Relacionado con productos y manuales para Equipo Rockwell-automation 1609-ENET Ethernet Network Card Quick Start