Rockwell-automation 1732E-OB8M8SR EtherNet/IP Dual Port 8-Point SOE In Manual de usuario descargar pdf (Pagina 27)

Rockwell Automation Publication 1732E-UM003B-EN-E - March 2014 17

Chapter

Install Your Module

Overview

This chapter shows you how to install and wire the 1732E ArmorBlock

EtherNet/IP Dual Port 8-Point Sequence of Events Input and Scheduled Output

Modules modules. The only tools you require are a flat or Phillips head

screwdriver and drill. This chapter includes the following topics:

Install the Module

To install the module:

• Set the network address

• Mount the module

• Connect the I/O, Network, and Auxiliary cables to the module.

Set the Network Address

The I/O block ships with the rotary switches set to 999 and DHCP enabled. To

change the network address, you can do one of the following:

• adjust the node address switches on the front of the module.

• use a Dynamic Host Configuration Protocol (DHCP) server, such as

Rockwell Automation BootP/DHCP.

• retrieve the IP address from nonvolatile memory.

The I/O block reads the switches first to determine if the switches are set to a

valid number. To set the network address:

1. Remove power.

2. Remove the switch dust caps.

3. Rotate the three (3) switches on the front of the module using a small

blade screwdriver.

Topic Page

Install the Module 17

Set the Network Address 17

Mount the Module 18

Wire the Module 19

Power Connectors 20

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 145 146

Sin comentarios

Rockwell-automation 1732E-OB8M8SR EtherNet/IP Dual Port 8-Point SOE In Manual de usuario Pagina 27