Rockwell-automation 1732E-OB8M8SR EtherNet/IP Dual Port 8-Point SOE In Manual de usuario descargar pdf (Pagina 33)

Rockwell Automation Publication 1732E-UM003B-EN-E - March 2014 23

Chapter

Configure the Module for Your

EtherNet/IP Network

Introduction

Before using the modules in an EtherNet/IP network, you need to configure

them with an IP address, subnet mask, and optional Gateway address. This

chapter describes these configuration requirements and the procedures for

providing them. Here are the ways you can do this:

• Use the Rockwell Automation BootP/DHCP utility, version 2.3 or

greater, that ships with RSLogix 5000 or RSLinx software. You can also

use this utility to reconfigure a device whose IP address must be changed.

• Use a third party DHCP (Dynamic Host Configuration Protocol) server.

• Use the Network Address switches.

• Have your network administrator configure the module via the network

server.

See the table for a list of where to find specific information in this chapter.

Configuration

Requirements

Before you can use your module, you must configure its IP address, its subnet

mask, and optionally, gateway address. You have the option to use the Rockwell

Automation BootP/DHCP utility, version 2.3 or greater, to perform the

configuration. You also have the option to use a DHCP server or the network

address switches to configure these parameters.

Topic Page

Configuration Requirements 23

IP Address 24

Gateway Address 25

Subnet Mask 26

Set the Network Address 27

Use the Rockwell Automation BootP/DHCP Utility 27

Save the Relation List 30

Use DHCP Software to Configure Your Module 30

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 145 146

Sin comentarios

Rockwell-automation 1732E-OB8M8SR EtherNet/IP Dual Port 8-Point SOE In Manual de usuario Pagina 33