Rockwell-automation 1788-CN2FFR EtherNet/IP and ControlNet to FOUNDATI Manual de usuario descargar pdf (Pagina 30)

28 Rockwell Automation Publication 1788-UM057B-EN-P - September 2014

Chapter 2 Set Up in the Studio 5000 Logix Designer Application

Master Configuration

1. Open the master configuration page from the config tree to access the

linking device master configuration settings.

2. Choose the Topology for the master linking device.

3. Enter the configuration values.

4. Click the Download Config button to download the settings to the

linking device.

The settings are stored in nonvolatile memory in the linking device.

5. Click the Apply button to store the configuration in the project file.

To p ol o g y

Choose the correct Topology mode for the application. The graphical

representation must be used to match the topology. See Appendix D

for available

options. Use this setting to configure redundant linking devices, redundant H1

media, and the internal H1 segment terminators.

FF Master Node

The H1 Master (linking device) needs a node number to operate on the H1

network. The default is node number 16 (0x10).

IMPORTANT

Do not modify the default node number; doing so can result in loss of

communication.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 103 104

Sin comentarios

Rockwell-automation 1788-CN2FFR EtherNet/IP and ControlNet to FOUNDATI Manual de usuario Pagina 30