Rockwell-automation 1788-CN2FFR EtherNet/IP and ControlNet to FOUNDATI Manual de usuario descargar pdf (Pagina 40)

38 Rockwell Automation Publication 1788-UM057B-EN-P - September 2014

Chapter 2 Set Up in the Studio 5000 Logix Designer Application

Adjust Block Parameters

To change the parameters of a block, right-click

the title portion of the block and choose

Parameters.

To enable a parameter for editing, click the box in

the En column. A green check mark indicates the

parameter is enabled for editing. Different

parameters will have different classes as shown in Tab le 4

Table 4 - Parameter Class Descriptions

1. Click a parameter that is enabled for editing to display a list of options to

choose from.

2. Select a new value in the pop-up dialog box and click OK.

Icon Parameter Class Description

Configurable parameter but non output

Input port

Read-only

Tune

Output port

Alarm

Parameter help (provides information about the parameter)

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 103 104

Sin comentarios

Rockwell-automation 1788-CN2FFR EtherNet/IP and ControlNet to FOUNDATI Manual de usuario Pagina 40