Rockwell-automation 2705 RediSTATION Operator Interface User Manual Manual de usuario descargar pdf (Pagina 58)

Publication 2705-UM001A-EN-P

C-4 User Configuration

Connecting Devices

This section shows how to connect devices to the DeviceNet Interface

Board and connect the DeviceNet cable to the DeviceNet terminal

block connector.

To install devices:

1. Connect the device terminals to the I/O connector using the I/O

cables. An I/O cable consists of a twisted (red/black) wire pair.

Each set of contacts or pilot light connects to an I/O cable.

Every 2 consecutive pins on the I/O connector connects to an

I/O cable connector. The I/O connector supports 2 outputs and

4 inputs.

ATTENTION

Do not connect I/O pins to standard control

voltages. See page C-2 for maximum input voltages.

I/O pins are not electrically isolated from the

DeviceNet circuitry.

I/O Connector

I/O Cable

To Device

Terminals

I/O Cable (up to 6)

I/O Connector

To Output (Pilot Light)

To Input (Contact)

Circuit

Board

LED

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 64

Sin comentarios

Rockwell-automation 2705 RediSTATION Operator Interface User Manual Manual de usuario Pagina 58