Rockwell-automation 2711E-ND7 PanelView File Transfer Utility User Man Manual de usuario descargar pdf (Pagina 48)

3–2 Uploading 1000e/1200e/1400e Application Files and Alarm History Files

To prepare the PanelView terminal for a serial upload:

1. Using the hardware keyswitch or the Goto Configure Mode

button, switch the PanelView terminal to the Configure mode.

2. In the Terminal Configuration screen, choose the Transfer Setup

button to display the Transfer Setup screen.

3. To change the settings, choose the Baud Rate, Parity, or Error

buttons to move the check mark to the setting you want.

• Baud RateĊThe speed at which data is transmitted over the

serial cable. The default setting for a serial transfer is

9600 baud.

• ParityĊUsed to check for accurate transmission of the data

between the development computer and terminal. The default

setting is None.

• ErrorĊUsed to check for errors in the data transmission.

Error transmission is either

CRCĊcyclical (or cyclic) redundancy check.

BCCĊblock check character. BCC is the default setting.

The settings that are defined in the Transfer Setup screen must

match the Transfer Utility’s settings.

4. When you have selected the required settings, choose OK to exit

this screen.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 108 109

Sin comentarios

Rockwell-automation 2711E-ND7 PanelView File Transfer Utility User Man Manual de usuario Pagina 48