Rockwell-automation 5730 DriveLogix5730 Controller for PowerFlex 700S Manual de usuario descargar pdf (Pagina 61)

Placing and Configuring Local I/O 3-11

inhibit or 0 to uninhibit). Use a SSV instruction to write the Mode attribute

back to the module. For example:

Sending Module Configuration Information

The controller sends module configuration information once module

connections are established.

The GSV instruction gets the current status of the module named “input_module.” The SSV instruction sets the state of “input_module” as either

inhibited or uninhibited.

When on, inhibits the module.

When off, uninhibits the module.

GSV ladder.tif

ATTENTION: If you make a configuration change to any

module in the system do one of the following to resend module

configuration data:

• cycle power to the controller

• inhibit and then uninhibit the bus

• inhibit and then uninhibit the individual module

• send a MSG instruction of type Module Reconfigure (for

information on configuring a MSG to send configuration data,

see the Logix5000 Controllers General Instructions Reference

Manual, publication 1756-RM003)

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 216 217

Sin comentarios

Rockwell-automation 5730 DriveLogix5730 Controller for PowerFlex 700S Manual de usuario Pagina 61