Rockwell-automation 8520-9API 9/Series OCI API Developer's Guide Manual de usuario descargar pdf (Pagina 130)

5–19OCI Data Server CNC Commands

Publication 8520-6.6 - August 1999

For example:

[ENTER_SERIAL_IO_MONITOR_MODE (2, 2)]

would request the serial I/O monitor for port B on the control be in

transmit mode. You must exit the serial I/O monitor before

continuing with normal control operation. Use the command

EXIT_SERIAL_IO_MONITOR_MODE to leave the serial I/O

monitor mode.

Important: This command does not apply to the 9/PC CNC.

EXIT_SERIAL_IO_MONITOR_MODE (no arguments)

This command is used to unload the serial I/O monitor. For

example:

[EXIT_SERIAL_IO_MONITOR]

will take the control out of the serial I/O monitor mode. You can not

exit the serial I/O monitor mode if the port is currently sending

diagnostic data.

Important: This command does not apply to the 9/PC CNC.

REPEAT_TX_SERIAL_IO (character)

This command repeatedly transmits a character out the serial port

when the I/O monitor is active. Specify the character to be sent out

the serial port as an argument for this command. The transmitted

character must be an integer (DINT) equivalent of the ASCII

character to transmit. For example:

[REPEAT_TX_SERIAL_IO (68)]

will repeatedly transmit the lone character “D” out the serial port.

Note this is used primarily for I/O monitor diagnostics. Use the

STOP_SERIAL_IO_MONITOR command to halt transmission.

Important: This command does not apply to the 9/PC CNC.

1 2 ... 125 126 127 128 129 130 131 132 133 134 135 ... 262 263

Sin comentarios

Rockwell-automation 8520-9API 9/Series OCI API Developer's Guide Manual de usuario Pagina 130