Rockwell-automation DC3E Non-Regenerative DC Drive User Guide 1/4 - 2 Manual de usuario descargar pdf (Pagina 19)

The chassis units do not have to be earth grounded. If you

choose to ground the chassis, use a star washer beneath the

head of at least one of the mounting screws to penetrate the

anodized chassis surface and to reach bare metal.

Isolation transformer

11Installation

ATTENTION: Distribution system capacity above the

maximum recommended system KVA requires the use

of an isolation transformer, a line reactor, or other

means of adding similar impedance to the drive power

input. Failure to observe these precautions could result

in damage to, or destruction of, the equipment



Input isolation transformers might be needed to help

eliminate the following:

· Damaging line voltage transients from reaching the

drive.

· Line noise from the drive back to the incoming power

source.

· Damaging currents that could develop if a point inside

the drive becomes grounded.

250-0287-rev2.qxd 3/12/01 10:27 AM Page 11

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 91 92

Sin comentarios

Rockwell-automation DC3E Non-Regenerative DC Drive User Guide 1/4 - 2 Manual de usuario Pagina 19