Rockwell-automation DC3E Non-Regenerative DC Drive User Guide 1/4 - 2 Manual de usuario descargar pdf (Pagina 44)

Operation

ATTENTION: Change voltage switch settings only

when the drive is disconnected from AC line voltage.

Make sure both switches are set to their correct

position. If the switches are improperly set to a lower

voltage position, the motor will not run at full voltage

and may cause damage to the transformer. If the

switches are improperly set to a higher voltage position,

the motor will overspeed, which may cause motor

damage, or result in bodily injury or loss of life.



ATTENTION: Only qualified technical personnel,

familiar with the construction and operation of this

equipment and the hazards involved, should install,

adjust, operate and/or service this equipment. Read and

understand this instruction manual in its entirety before

proceeding. Failure to observe this precaution could

result in severe bodily injury or loss of life.

ATTENTION: All adjustments to these components

should be made with power removed. Failure to

observe this precaution could result in severe bodily

injury or loss of life.



250-0287-rev2.qxd 3/12/01 10:27 AM Page 36

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 91 92

Sin comentarios

Rockwell-automation DC3E Non-Regenerative DC Drive User Guide 1/4 - 2 Manual de usuario Pagina 44