Rockwell-automation DC3E Non-Regenerative DC Drive User Guide 1/4 - 2 Manual de usuario descargar pdf (Pagina 27)

19Installation

Connect a motor to terminals A1 and A2 as shown in

Figure 6 (page 23). Ensure that the motor voltage rating is

consistent with the drive’s output voltage.

Power input

ATTENTION: Installation of a master power switch in

the input line is required. This is the only way to

disconnect power from the motor. The user is

responsible for assuring safe conditions for operating

personnel by providing suitable guards, audio or visual

alarms, or other devices. Failure to observe these

precautions could result in bodily injury.



Connect the AC line power leads to terminals L1 and L2 as

shown in Figure 6 (page 23). Install a master power switch

in the voltage input line, as shown in Figure 6. The switch

contacts should be rated at a minimum of 250 volts and

200% of maximum drive current.

250-0287-rev2.qxd 3/12/01 10:27 AM Page 19

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 91 92

Sin comentarios

Rockwell-automation DC3E Non-Regenerative DC Drive User Guide 1/4 - 2 Manual de usuario Pagina 27