Rockwell-automation DC3E Non-Regenerative DC Drive User Guide 1/4 - 2 Manual de usuario Pagina 22

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 92
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 21
14
Figure 4. Speed Adjust Potentiometer
Installation
Speed adjust potentiometer
Install the circular insulating disk between the mounting
panel and the 10K ohm speed adjust potentiometer (see
Figure 4). Mount the speed adjust potentiometer through a
0.38 inch (10 mm) hole with the hardware provided. Twist
the speed adjust potentiometer wire to avoid picking up
unwanted electrical noise. If potentiometer leads are longer
than 18 inches (46 cm), use shielded cable.
250-0287-rev2.qxd 3/12/01 10:27 AM Page 14
Vista de pagina 21
1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 91 92

Comentarios a estos manuales

Sin comentarios