Rockwell Automation 1203-SSS Manual de usuario descargar pdf (Pagina 13)

Publication 1203-5.14 – September 1998

Chapter

Installation

Chapter Objectives

Chapter 2 provides the information that you need to install the

1203-SSS converter. In this chapter, you will read about the

following:

• Tools and equipment needed for the installation.

• Selecting cables for SCANport and serial connections.

• Installing the converter.

• Removing the converter.

Required Tools and Equipment

To install your 1203-SSS converter, you will need the following:

• 1203-SSS converter.

• Appropriate cables for SCANport and serial connections. Refer to

the “Selecting Cables” section in this chapter.

Selecting Cables

To connect the 1203-SSS converter to the SCANport product and

computer, you must use the appropriate SCANport and serial cables.

The 1203-C10 SCANport cable and 1203-SFC serial cable that are

shipped with each converter are all you should need to connect any

SCANport product to a computer.

Important: If you are connecting the converter to a hand-held

personal computer (HPC) or PalmPC running Windows CE™, you

must purchase an additional null cable converter (1203-SNM) or any

standard PC null cable with two male 9-pin sub-miniature D

connectors.

Important: To provide proper termination of the 1203-SFC cable

shield, the chassis of the PC should be properly grounded. If this is

not possible or practical, then a ground wire should be connected to

the 1203-SFC shield at the shell of the 9-pin sub-miniature D

connector.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 35 36

Sin comentarios

Rockwell Automation 1203-SSS Manual de usuario Pagina 13