Rockwell Automation 1203-SSS Manual de usuario descargar pdf (Pagina 29)

Publication 1203-5.14 – September 1998

Appendix

1203-SSS Converter Parameters

Appendix Objectives

Appendix B provides information on the 1203-SSS converter’s

parameters. In this appendix, you will read about the following:

• Factory-default settings for the converter.

• Parameters in the converter.

Factory-Default Settings

The factory-default settings of the 1203-SSS converter enable the

following functions:

• Node address of 1.

• Baud rate of 9600.

• If control data is being transmitted and a time-out occurs, the

SCANport product will be faulted by the converter.

If you wish to change any of these functions you must connect to the

converter and edit its parameters. To do so, refer to:

• The “Parameters” section in this chapter for detailed information

about each of the converter’s parameters.

• Instructions in Chapter 3, Configuring the 1203-SSS Converter,

on establishing a serial connection.

• Instructions in Chapter 3, Configuring the 1203-SSS Converter,

on how to edit parameters.

Parameters

The following table provides information on the parameters for the

1203-SSS converter.

#Name

Valid Values/

Settings

Default Writable

Reset or

Power Cycle

to Take

Effect

Description

SCANport Adapter

0 – 7 0 No No Identifies the port number to which the converter is

connected on the SCANport product.

DF-1 Address

0 – 254 1 Yes Yes Provides the node address for the 1203-SSS converter.

Serial Port Rate

9600

19200

9600 Yes Yes Sets the baud rate for the 1203-SSS converter’s serial/DF1

port.

Important:

If you change the baud rate in the converter, you

must also change it in your terminal emulation software or

terminal.

Important:

For information on editing parameters, refer to Chapter 3,

Configuring the 1203-SSS Converter

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 35 36

Comentarios a estos manuales

Sin comentarios

Rockwell Automation 1203-SSS Manual de usuario Pagina 29

Comentarios a estos manuales