Rockwell-automation 1734-AENT, Series B POINT I/O EtherNet/IP Adapter Manual de usuario descargar pdf (Pagina 32)

22 Rockwell Automation Publication 1734-UM018B-EN-E - October 2013

Chapter 3 Configure the Adapter with RSLogix5000 software

Set the

Network Address

The adapters ship DHCP-enabled and with the Network address thumbwheel

switches set to 999. You can set the network Internet Protocol (IP) address as

follows.

Set the Network Address for POINT I/O Adapters

• Use the thumbwheel switches located on the adapter. Press either the + or -

buttons to change the number and assign the IP address.

• Use a Dynamic Host Configuration Protocol (DHCP) server, such as

Rockwell Automation BootP/DHCP.

• Retrieve the IP address from non-volatile memory.

The adapter reads the thumbwheel switches first to determine if the switches are

set to a valid number. You set the node address by using the 3-position

thumbwheel switch. Press the + or - buttons to change the number. Valid settings

range from 001…254.

When you use the thumbwheel to assign an address and set it to 001, the adapter

gateway address is set to 0.0.0.0. and the subnet mask is set to 255.255.255.0 .

When you use the thumbwheel to assign an IP address between 002...254, the

adapter gateway address is set to 192.168.1.1.

The adapter does not have a host name assigned, or use any Domain Name

System when using the thumbwheel settings.

If the switches are set to an invalid number (for example, 000 or a value greater

than 254 excluding 888), the adapter checks to see if DHCP is enabled. If DHCP

is enabled, the adapter requests an address from a DHCP server. The DHCP

server also assigns other Transport Control Protocol (TCP) parameters.

43264

Network address thumbwheel

Press either the + or - buttons

to change the number and

assign the IP address.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 117 118

Sin comentarios

Rockwell-automation 1734-AENT, Series B POINT I/O EtherNet/IP Adapter Manual de usuario Pagina 32