Rockwell-automation 1772-LP3 PLC - 2/30 Programmable Controller Progra Manual de usuario descargar pdf (Pagina 180)

100

101

Report Generation

Chapter 9

912

Messages can be printed through program control automatically be

energizing specific message request bits using output latch and output

unlatch instructions.

Automatic report generation can be accessed if the keyswitch is in the

TEST, RUN, or RUN/PROGRAM position by pressing [SEARCH] 40 or

by pressing [M] [R] [RETURN]. It can also be activated automatically

upon initialization of the industrial terminal by setting parity switches 4

and 5 up on the industrial terminal’s main logic board (Figure 9.3).

Figure 9.3

Parity

Switch Location

Halftone

Once automatic report generation is activated, the message request bits are

scanned by the industrial terminal for zero to one transition. Each time one

of the request bits goes true, the corresponding message will be printed

automatically.

Automatic report generation can be terminated by pressing [ESC]. To

return to ladder diagram display, press [ESC] again. Pressing [CANCEL

COMMAND] will also terminate automatic report generation and return

to ladder diagram display if automatic report generation was entered by a

command from a peripheral device.

9.3

Automatic Report

Generation

1 2 ... 175 176 177 178 179 180 181 182 183 184 185 ... 345 346

Comentarios a estos manuales

Sin comentarios

Rockwell-automation 1772-LP3 PLC - 2/30 Programmable Controller Progra Manual de usuario Pagina 180

Comentarios a estos manuales

Relacionado con productos y manuales para Equipo Rockwell-automation 1772-LP3 PLC - 2/30 Programmable Controller Progra