Rockwell-automation 20-750-PBUS Profibus DPV1 Option Module Manual de usuario descargar pdf (Pagina 25)

Rockwell Automation Publication 750COM-UM004B-EN-P - September 2012 25

Installing the Option Module Chapter 2

Applying Power

Apply power to the drive. The option module receives its power from the drive.

When you apply power to the option module for the first time, its topmost

PORT status indicator should be steady green or flashing green after

initialization. If it is red, there is a problem. See Chapter

7, Troubleshooting.

Start-Up Status Indications

The drive STS (status) indicator can be viewed on front of the drive after power

has been applied. The option module status indicators can be viewed with the

drive cover open or removed (Figure 5

Figure 5 - Drive and Option Module Status Indicators

ATTENTION: Risk of equipment damage, injury, or death exists.

Unpredictable operation may occur if you fail to verify that parameter

settings are compatible with your application. Verify that settings are

compatible with your application before applying power to the drive.

➊

➋

➌

➍

Drive Control Pod

See Table 2

for

possible start-up

status indications

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 95 96

Sin comentarios

Rockwell-automation 20-750-PBUS Profibus DPV1 Option Module Manual de usuario Pagina 25