Rockwell-automation 20-750-PBUS Profibus DPV1 Option Module Manual de usuario descargar pdf (Pagina 26)

26 Rockwell Automation Publication 750COM-UM004B-EN-P - September 2012

Chapter 2 Installing the Option Module

Table 2 - Drive and Option Module Start-Up Status Indications

After verifying correct operation, swing down the drive HIM bezel to its closed

position and install the drive cover. For more details on status indicator

operation, see page 66

and page 67.

Item Name Color State Description

Drive STS Indicator

➊

STS

(Status)

Green Flashing Drive ready but not running, and no faults are present.

Steady Drive running, no faults are present.

Yellow Flashing When running, a type 2 (non-configurable) alarm condition exists – drive

continues to run. When stopped, a start inhibit condition exists and the

drive cannot be started (see drive parameter 933 - [Start Inhibits]).

Steady A type 1 (user configurable) alarm condition exists, but the drive

continues to run.

Red Flashing A major fault has occurred. Drive will stop. Drive cannot be started until

fault condition is cleared.

Steady A non-resettable fault has occurred.

Red/Yellow Flashing

Alternately

A minor fault has occurred. Use drive parameter 950 - [Minor Flt Config]

to enable. If not enabled, acts like a major fault. When running, the drive

continues to run. System is brought to a stop under system control. The

fault must be cleared to continue.

Yellow/Green Flashing

Alternately

When running, a type 1 alarm exists.

Green/Red Flashing

Alternately

Drive is updating.

Option Module Status Indicators

➋

PORT — Off The option module is not powered or connected properly to the drive.

Red Flashing The option module is not receiving any communication from drive.

Steady The option module detected a duplicate or invalid port ID.

Green Flashing The option module is establishing communication with drive.

Steady The option module is properly connected and communicating with drive.

Orange Steady The drive to which option module is connected is not an Allen-Bradley

brand.

➌

MOD — Off The option module is not powered or connected properly to the drive.

Red Flashing The option module has failed the firmware test or firmware update is in

progress.

Steady The option module has failed the hardware test.

Green Flashing The option module is operational but is not transferring I/O data.

Steady The option module is operational and is transferring I/O data.

➍

NET A — Off The option module cannot establish network communication or has

experienced a Communication Timeout.

Red Flashing The option module has detected a Network Configuration Error.

Steady The option module has experienced an internal network controller error

(Profibus ASIC Self-Test failure).

Green Steady The option module is properly connected and communicating over the

Profibus network.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 95 96

Comentarios a estos manuales

Sin comentarios

Rockwell-automation 20-750-PBUS Profibus DPV1 Option Module Manual de usuario Pagina 26

Comentarios a estos manuales

Relacionado con productos y manuales para Equipo Rockwell-automation 20-750-PBUS Profibus DPV1 Option Module