Rockwell-automation 25-COMM-P PowerFlex PROFIBUS DPV1 Adapter Manual de usuario descargar pdf (Pagina 13)

Rockwell Automation Publication 520COM-UM004A-EN-E - November 2013 13

Chapter 2

Installing the Adapter

This chapter provides instructions for installing the adapter in a

PowerFlex 520-series drive.

Preparing for an Installation

Before installing the adapter, do the following:

• Read the PROFIBUS Installation Guideline for details on PROFIBUS

networks.

• Verify that you have all required equipment.

See Required Equipment

on page 9.

Commissioning the Adapter

To commission the adapter, you must set the Endianness and a unique node

address that is used by the network. See the Glossary

on page 85 for details about

node addresses.

There are two methods for configuring the adapter’s Endianness and node

address:

• Using the onboard DIP Switches;

• Using adapter parameters – Use adapter parameters when you want more

flexibility in setting up the node address. To set the node address using

adapter parameters, see Setting the Node Address

on page 25.

Topic Page

Preparing for an Installation

Commissioning the Adapter 13

Connecting the Adapter to the Drive 15

Connecting the Adapter to the Network 18

Network Termination 20

Applying Power 20

IMPORTANT

Regardless of the method used to set the adapter’s node address, each node on

the network must have a unique node address.

ATTENTION: Risk of equipment damage exists. The adapter contains ESD

(Electrostatic Discharge) sensitive parts that can be damaged if you do not

follow ESD control procedures. Static control precautions are required when

handling the adapter. If you are unfamiliar with static control procedures, see

Guarding Against Electrostatic Damage (publication 8000-4.5.2

)

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 93 94

Sin comentarios

Rockwell-automation 25-COMM-P PowerFlex PROFIBUS DPV1 Adapter Manual de usuario Pagina 13