Rockwell-automation 2705 RediPanel Push Button Module Manual de usuario Pagina 15

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 100
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 14
Chapter 2
Configuring the RediPANEL Module
2–3
The RediPANEL module has two DIP Switch banks.
Switch Bank Function
Switch Bank 1 (SW-1) Sets rack address.
Switch Bank 2 (SW-2) Controls baud rate, flashing lamps, fault mode
behavior, handshaking and last states.
The DIP Switch banks are located on the back of the RediPANEL module.
You can access the DIP switches by opening the back panel, as shown below.
DIP Switches
800T/H Module
800A Push Button Module
DIP Switches
800EM/EP Module
(Steel enclosure mounting shown.
Other styles similar)
DIP Switches
The following figure shows ON/OFF positions of the rocker style switches.
ON
OFF
FRONT SIDE
ON
ON
OFF
FRONT SIDE
OFF
ON and OFF switch settings are indicated by shading.
!
ATTENTION: Remove power from the module before setting
switches. Switch settings are scanned only on power-up.
The new settings take effect when you power-up the module.
DIP Switches
Vista de pagina 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 99 100

Comentarios a estos manuales

Sin comentarios