Rockwell-automation 2705 RediPanel Push Button Module Manual de usuario descargar pdf (Pagina 93)

A–B

Appendix

G–1

Installing/Replacing Push Buttons

This appendix shows how to install or replace push buttons in RediPANEL

modules.

ATTENTION: To avoid electrical shock or unintended operation

of the equipment, disconnect power before servicing.

1. Open enclosure by loosening the screws on the back of

RediPANEL module. Guide the modules back door open.

2. Disconnect RediPANEL wiring from the push button you want to

replace.

3. Remove the push button from the enclosure.

4. Mount the replacement push button in the enclosure.

5. Attach RediPANEL wiring to the replacement push button. See

Push Button and Selector Switch Connection Examples on next page.

6. Carefully guide the modules back door closed. Be sure that the

wiring is not pinched between the side plate and the chassis.

Tighten the screws on the back of the RediPANEL enclosure.

Figure G.1

Replacing 800T/H Push Buttons

-344-3

Install

Replac

800T/H Push Buttons

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 99 100

Sin comentarios

Rockwell-automation 2705 RediPanel Push Button Module Manual de usuario Pagina 93