Rockwell-automation 2705 RediPanel Push Button Module Manual de usuario descargar pdf (Pagina 85)

LED Upgrade Kit

Appendix C

800A Switch Replacement Kit

C–2

1. Place the Push Button Module on a flat surface and locate the 4 screws

connecting the push button faceplate to the sheet metal housing.

Screws

2. Remove the screws and carefully slide the faceplate out of the housing.

Note: You will be able to slide the faceplate out approximately

1 inch (25 mm).

3. Unplug the ribbon cable(s) on the faceplate from the push button printed

circuit (PC)board. Note: 8 and 16 Push Button Modules have 1

ribbon cable and 32 Push Button Modules have 2 ribbon cables.

Ribbon Cables

Ribbon Cable

32 Button Module 8 or 16 Button Module

4. A 2-wire assembly is also connected to the PC board. Disconnect the

connector plug for this 2 wire assembly.

5. Select the correct template for the Push Button Module (8, 16, or 32

button) you are modifying. Place the Push Button Module face down on

the template.

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 99 100

Sin comentarios

Rockwell-automation 2705 RediPanel Push Button Module Manual de usuario Pagina 85