Rockwell-automation 2705 RediPanel Push Button Module Manual de usuario descargar pdf (Pagina 49)

Chapter 4

Programming the RediPANEL Modules

4–10

After entering the ladder logic, place the PLC in the RUN or REMOTE RUN

mode to test your logic. Monitor the ON/OFF status of the input and output

bits of the RediPANEL push button module by pressing [SEARCH] 53

followed by the address to monitor. This displays the input or output image

table for that address.

The following figure shows what the I/O image table looks like when you

press push button #1 for the previous example.

120

Push Button #1, Illuminate the Lamp in Button #4

Input Image Table

1/4 Rack

Module Group

(Word)

00000 00001 00000 0 0001

Switch Status Bits

Lamp Control Bits

012345671011121314151617 012345671011121314151617

Output Image Table

1/4 Rack

Special Considerations

If the MODE SELECT DIP Switch #5 (Fault Table) on the 1772-SD2 is set

to OFF, a remote I/O fault table is generated and remote I/O rack #2 must be

declared used. These fault status bits are generated in the addresses

associated with Module Groups 5 and 6 of remote I/O rack #2. (See

Publication 1772-2.18).

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 99 100

Sin comentarios

Rockwell-automation 2705 RediPanel Push Button Module Manual de usuario Pagina 49