Rockwell-automation 2755-DM9, -DM9E High Speed Decoder Manual de usuario descargar pdf (Pagina 40)

Chapter 4

Configuring Your Decoder

4–13

(next) setup screen you would press the [RETURN] key. To select another of

the displayed commands, press the [SPACE] key until the desired command

is highlighted and then press the [RETURN] key. Pressing the [ESC] key

after selecting the command bar will return you to the select operation menu.

The following are explanations of each command in the command bar:

• NEXT PAGE - Selecting this command will display the other setup

screen. Remember that there are two setup screens used to configure the

decoder.

• THIS PAGE - Selecting this command will return you to the top of the

current setup screen.

• RECALL - Selecting this command will recall all the previously SAVED

configuration parameters from the decoder’s Electrically Erasable

Programmable Read Only Memory (EEPROM) to the decoder’s Random

Access Memory (RAM). Once moved into the decoder’s RAM, the

recalled configuration is displayed and controls the operation of the

decoder.

• SAVE - Selecting this command will save all the configuration parameters

to the decoder’s EEPROM. You must use the save function after

programming, or the decoder’s operating configuration will revert back to

the original configuration after a restart (or power loss) of the decoder.

• DEFAULT - Selecting this command will change the setup to the factory

default selections. Refer to Appendix B for the default parameters. If the

default values meet the requirements of your application, you do not have

to program the decoder.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 166 167

Sin comentarios

Rockwell-automation 2755-DM9, -DM9E High Speed Decoder Manual de usuario Pagina 40