Rockwell-automation 4100 AEC Absolute Encoder Converter Installation Manual de usuario descargar pdf (Pagina 40)

Publication 4100-UM052B-EN-P - October 2001

32 Setup

Powering the AEC

The AEC has reverse polarity protection. However, always take care to

observe correct polarity when you connect the power to your unit. If

power is connected with the wrong polarity, no damage is done. The

AEC simply does not function until the polarity is corrected. There is

no warning or indication of an incorrect polarity connection.

The AEC also has over current protection provided by a fuse on the

printed circuit board. The fuse is a 2 amp/250V, 5mm radial. A spare

fuse is located on the lower left portion of the printed circuit board

and is clearly marked “Spare Fuse”. If the fuse blows, always

determine and correct the reason it blew before installing the new

fuse.

AEC With GML Commander

The AEC can only be used with GML Commander version 4.01 or

higher. There are several steps that must be taken in GML Commander

before the AEC can be used within a GML Commander diagram. This

section outlines the necessary steps. For more detail about individual

steps, see the GML Commander Reference Manual (publication

number GMLC-5.2), the “Configuring Axis Use” chapter, “Defining

Feedback” section.

Adding AEC to your Commander Diagram

To add the AEC to your GML Commander diagrams go to GML

Commander and do the following:

1. Select the Configure menu option from the opening GML

Commander screen.

ATTENTION

Never replace the fuse with the unit under power. When

replacing the fuse, make sure it is of the proper rating.

IMPORTANT

Before powering the AEC, make sure that it has been

properly installed and configured according to the

instructions contained in this manual.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 60 61

Sin comentarios

Rockwell-automation 4100 AEC Absolute Encoder Converter Installation Manual de usuario Pagina 40