Rockwell-automation 8510 AC Spindle Drive System User Manual Manual de usuario descargar pdf (Pagina 101)

Start-Up

Chapter 9

9-97

a) Assure that Drive Enable and Coast to Stop are Off.

b) Use GEAR RANGES – Select Range to select gear range “1” for

programming. If a dual winding motor (1327AD series) is being

used, select gear range “1L.”

c) Under GEAR RANGES – Default Data, select “YES.” This

assures that all parameters are initialized to the default values.

d) Under MOTOR SELECT – Catalog Num, scroll down the list of

motor catalog numbers and select the number that matches the

motor being used in this system.

e) Under PARAMETER SET – ELECT CONFIG – Drive Cat Num,

select the catalog number of the drive being used in this system.

f) Complete the remainder of the configuration and presetting of

drive parameters for gear range 1 or 1L.

g) If a multi-speed gearbox is being used (or multiple gear range

parameter sets will be used), use GEAR RANGES – Select Range

to select gear range “2” for programming. If a dual winding

motor (1327AD series) is being used, select gear range “1H.”

h) Under GEAR RANGES – Copy Data, select “RANGE 1” or

“RANGE 1L” if the dual winding motor is being used, as the

source to copy data from.

i) If the configuration or parameter presetting of this gear range is to

be different from the parameters set in step e, adjust the

parameters for this gear range.

j) Repeat steps f, g, and h for each gear range data set that will be

used in this application. For dual winding motors, both the “L”

and “H” data sets must

be programmed for each gear range data

set.

k) Up to now, all parameter changes have been held in RAM. To

permanently store the changes in EEPROM, it is necessary to exit

the DRIVE SETUP mode. Simultaneously press the Mode and

Scroll – keys twice. This will cause the display to change to

DISPLAY TYPE – METER DISPLAY and all parameter changes

will be written to EEPROM. When the data is being written to

EEPROM, the “←” symbol will be momentarily shown at

character 3 of line 2 on the display.

Once the motor and drive are defined for each gear range data set,

the drive is ready to run at a performance level determined by the

initial settings. The default parameter values will provide a

relatively low level of performance.

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 153 154

Comentarios a estos manuales

Sin comentarios

Rockwell-automation 8510 AC Spindle Drive System User Manual Manual de usuario Pagina 101

Comentarios a estos manuales

Relacionado con productos y manuales para Equipo Rockwell-automation 8510 AC Spindle Drive System User Manual