Rockwell-automation SA3100 Distributed Power System Drv Config,Program Manual de usuario descargar pdf (Pagina 36)

2-24

SA3100 Drive Configuration and Programming

2.5 Configuring Flex I/O

The Configure Flex I/O Parameter Entry Screen allows you to configure your Flex I/O

Modules, if Flex I/O is being used with your system. See figure 2.14.

A maximum of three Flex I/O modules is allowed. Module 0 and Module 1 must be

digital; Module 2 can be either digital or analog.

• Module 0

Select a digital I/O module from the pull-down list. Only the supported digital I/O

modules will be displayed. There is no default selection. You must choose a module

from the list.

• Module 1

Select a digital I/O module from the pull-down list. Only the supported digital I/O

modules will be displayed. There is no default selection. You must choose a module

from the list.

• Module 2

Select an analog or digital I/O module from the pull-down list of supported modules.

There is no default selection. You must choose a module from the list.

• Filter Time

This parameter is used only with input modules. The system determines the default

filter time for the module selected. You may select a different time from a pull-down

list.

Figure 2.14 – Flex I/O Parameter Entry Screen

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 161 162

Sin comentarios

Rockwell-automation SA3100 Distributed Power System Drv Config,Program Manual de usuario Pagina 36