Rockwell-automation SA500 Drive Configuration and Programming Manual de usuario descargar pdf (Pagina 75)

Configuring the UDC Module’s Registers

3-43

3.7 UDC Module Test I/O Registers (Registers 1000-1017)

This view is used to configure the UDC module’s Test Switch Inputs Register and the

Meter Port Setup Registers.

3.7.1 UDC Module Test Switch Inputs Register (Register 1000)

This view is used to configure the register that displays the status of the test switches

and LED indicators on the UDC module. Writing to this register will not change the

state of the LEDs. The status of this register is retained during a Stop All.

UDC Test Switch Inputs Register 1000

UDC Push-button Bit 0

The UDC Push-button bit is on when the

UDC’s push-button is pressed.

Hex Value:

0001H

Sug. Var. Name:

UDC_PB@

Access:

Read only

UDC Error Code:

N/A

LED:

N/A

UDC Switch Up Bit 1

The UDC Switch Up bit is on when the test

switch is in the up position.

Hex Value:

0002H

Sug. Var. Name:

SWIT_UP@

Access:

Read only

UDC Error Code:

N/A

LED:

N/A

UDC Switch Down Bit 2

The UDC Switch Down bit is on when the

test switch is in the up position.

Hex Value:

0004H

Sug. Var. Name:

SWIT_DN@

Access:

Read only

UDC Error Code:

N/A

LED:

N/A

Operating System OK LED Bit 8

The Operating System OK LED bit shows

the status of the Operating System OK LED

on the UDC module (0 = OFF; 1 = ON).

Hex Value:

0100H

Sug. Var. Name:

N/A

Access:

Read only

UDC Error Code:

N/A

LED:

OS OK on UDC

module

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 125 126

Comentarios a estos manuales

Sin comentarios

Rockwell-automation SA500 Drive Configuration and Programming Manual de usuario Pagina 75

Comentarios a estos manuales

Relacionado con productos y manuales para Equipo Rockwell-automation SA500 Drive Configuration and Programming