Rockwell-automation 2706-ND1 DL40 OFFLINE PROGRAMMING SFTWR.USER MANUA Manual de usuario descargar pdf (Pagina 101)

Chapter 6

The Transfer Menu

6–13

ATTENTION: Before the upload begins, you will see one of the

following warnings. Which one you see depends on the type and

access settings of your DH+ or Ethernet hardware device.

WARNING: Incorrect address selection could corrupt data in

a non-DL40 device. Verify that the correct Communication

File is selected.

WARNING: Incorrect address selection could corrupt data in

a non-DL40 device. Verify that the correct Communication

File is selected.

DH+ Network Access is set to Local.

WARNING: Incorrect address selection could corrupt data in

a non-DL40 device. Verify that the correct Communication

File is selected.

DH+ Network Access is set to Remote (Bridge)

– Local Address is __.

– Remote Bridge Address is __.

Be sure the selected communication file has the correct

address parameters, and change them if necessary before

continuing.

To specify a new Communication File, highlight Create Communication

File (in either the Download (Remote I/O) or Upload (Remote I/O) menus)

and press [↵ ]. You will be asked to specify a file name. To create a file in

another directory, highlight Directory and press [↵ ] and the Program Data

directory window will open. Enter the directory in the form:

Drive:\Root\Subdir

Press [↵ ]. The Communication File window will open. Highlight the

parameter you want to set and press [↵ ]. Select parameter setting and press

[↵ ]. When you highlight Hardware Device and press [↵ ], a pop-up

window will open from which you can select the hardware device you are

using. Set device parameters.

Creating a New

Communications File

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 138 139

Sin comentarios

Rockwell-automation 2706-ND1 DL40 OFFLINE PROGRAMMING SFTWR.USER MANUA Manual de usuario Pagina 101