Rockwell-automation 2706-ND1 DL40 OFFLINE PROGRAMMING SFTWR.USER MANUA Manual de usuario descargar pdf (Pagina 104)

Chapter 6

The Transfer Menu

6–16

If you choose ETHERNET, you must then specify an IP Address in the

appropriate field. IP Addresses take the following form:

X.X.X.X

where X is a decimal number from 0 through 255. Consult your network

administrator to obtain an IP Address.

Setting Device Parameters for a DH+ Network

Additional transfer parameters may be necessary when you select DH+

communications devices. For card numbers 1784-KT, 1784-KT2, 1784-KL,

1784-KTX, and 1784-PCMK devices, you must specify the DH+

Connection Type and DH+ Network Access.

Figure 6.12

1784-KT, KTX, PCMK configuration screen for DH+ network

Parameter Acceptable values

DH+ Connection Type Direct

Multidrop

DH+ Network Access Local

Remote (Bridge)

DH+ Connection Type

Select Direct if your programming computer and your PLC-5 are the only

devices on the DH+ link, or if there are multiple devices on the link and your

programming computer is the first or the last physical device on the link.

Select Multidrop if there are multiple devices on the link and your

programming computer is not first or last physical device on the link.

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 138 139

Sin comentarios

Rockwell-automation 2706-ND1 DL40 OFFLINE PROGRAMMING SFTWR.USER MANUA Manual de usuario Pagina 104