Rockwell-automation 2706-ND1 DL40 OFFLINE PROGRAMMING SFTWR.USER MANUA Manual de usuario descargar pdf (Pagina 105)

Chapter 6

The Transfer Menu

6–17

DH+ Network Access

Select Local if the PLC to which the DL40 is attached is on the same DH+

link as the programming computer.

Select Remote (Bridge) if the PLC to which the DL40 is attached is on a

separate DH+ link from the DH+ link to which your programming computer

is attached, with the two connected by Data Highway.

If you select Remote (Bridge), then you must specify the Local and Remote

Bridge Addresses.

Parameter Acceptable values

Local Bridge Address 0 to 376 (octal)

Remote Bridge Address 0 to 376 (octal)

The Local Bridge Address is the Data Highway address that you assign to

the module connecting the DH+ link on which your programming computer

resides to the Data Highway. This address must match the settings of the DIP

switches on the module.

The Remote Bridge Address is the Data Highway address that you assign

to the module connecting the DH+ link on which the PLC-5 to which the

DL40 is connected resides to the Data Highway. This address must match the

settings of the DIP switches on the module.

Setting Device Parameters for an Ethernet Network

Additional transfer parameters may be necessary when you select an Ethernet

communications device. For Ethernet devices, you must specify the Routing,

Pushwheel, and Channel.

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 138 139

Sin comentarios

Rockwell-automation 2706-ND1 DL40 OFFLINE PROGRAMMING SFTWR.USER MANUA Manual de usuario Pagina 105