Rockwell-automation 2711 Standard PanelView Operator Terminal User Man Manual de usuario descargar pdf (Pagina 120)

120 Publication 2711-UM014G-EN-P - September 2008

Chapter 5 Running Applications

Follow these steps to enter a value by using the keypad enable

button.

1. Press the keypad enable button.

The scratchpad opens.

2. Enter the value by using the terminal keypad and press Enter ↵ .

Follow these steps to change an entry on a scratchpad.

1. Press the backspace ← key to delete one character at a time.

2. Enter a new value and press Enter ↵ .

Follow these steps to cancel a scratchpad.

1. Press the Backspace

← key to delete one character at a time.

When pressing the Backspace

← key in an empty scratchpad

PanelView 300, 300 Micro Terminal Thumbwheel Scratchpad

The thumbwheel scratch pad lets you enter values on terminals

without a numeric keypad or touch screen by cycling through the

available characters one position at a time. Use the Up and Down

cursors to cycle through the available characters. The thumbwheel

scratchpad shows:

• display area where the value is entered or modified

• ESC - F1 key to exit the scratchpad without saving any changes

or sending a value

Scroll through and select digits 0…9. You can select the sign (+, -)

from the leftmost column. If the decimal point is keypad controlled,

you can also select a decimal point (if one has not been previously

selected).

Keys Function

Left / Right Cursor

Moves the cursor one position to the left or right in the

display area. The cursor wraps around to the opposite

side when reaching the leftmost or rightmost character,

Up /Down Cursor

Cycles through the available characters at the cursor

position.

Enter Key Send the numeric value to the logic controller. Leading

and trailing spaces are removed.

TIP

The Up/Down/Left/Right cursor keys can have an autorepeat

configured. If you hold down the key, the key is repeated at the

set key repeat rate.

1 2 ... 115 116 117 118 119 120 121 122 123 124 125 ... 291 292

Sin comentarios

Rockwell-automation 2711 Standard PanelView Operator Terminal User Man Manual de usuario Pagina 120