Rockwell-automation 2711 Standard PanelView Operator Terminal User Man Manual de usuario Pagina 151

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 292
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 150
Publication 2711-UM014G-EN-P - September 2008 151
Installing the PV550 Terminal Chapter 8
PV550 Keypad, Keypad & Touch Screen Terminals
PV550 Touch Screen Terminal
8. Alternately tighten the self-locking nuts until the terminal is held
firmly against the panel.
9. Tighten nuts to a torque of 1.13 Nm (10 lb-in).
Do not over-tighten.
ATTENTION
Mounting nuts must be tightened to a torque of 1.13 Nm
(10 lb-in) to provide a proper seal and to prevent
potential damage to the terminal. Allen-Bradley
assumes no responsibility for water or chemical damage
to the terminal or other equipment within the enclosure
because of improper installation. A properly installed
terminal has a small gap between the bezel and
enclosure.
Self-locking nuts (6
used, 8 provided)
Protective installation label
Mounting Studs (3 top, 3 bottom)
Protective installation label
Self-locking nuts
(4 used, 8 provided)
Mounting Studs (2 left, 3 right)
Vista de pagina 150
1 2 ... 146 147 148 149 150 151 152 153 154 155 156 ... 291 292

Comentarios a estos manuales

Sin comentarios