Rockwell-automation 2711P PanelView Plus Terminal User Manual Manual de usuario descargar pdf (Pagina 155)

Publication 2711P-UM001J-EN-P - November 2009 155

Install and Replace Components Chapter 6

8. Insert the new battery.

9. Attach the logic module by aligning the two connectors on the

bottom of the module with the connectors on the terminal.

10. Push down on the logic module until firmly seated.

11. Tighten the six captive screws that secure the logic module to a

torque of 0.58 Nm (5…7 lb•in).

12. Attach the communication module (if necessary) and tighten the

four screws to a torque of 0.58 Nm (5…7 lb•in).

Replace the Bezel

It is not necessary to remove the logic module or communication

module before removing the bezel, except on the PanelView Plus 700

terminal.

Remove the Display Module Bezel

Follow these steps to remove the display module bezel on a 700 to

1500 terminal.

1. Disconnect power from the terminal.

2. Set the terminal, display side down, on a flat stable surface.

IMPORTANT

Use only replacement battery 2711P-RY2032.

ATTENTION

Wear a properly grounded ESD wristband before

touching any of the electronic components in the

logic module.

1 2 ... 150 151 152 153 154 155 156 157 158 159 160 ... 245 246

Sin comentarios

Rockwell-automation 2711P PanelView Plus Terminal User Manual Manual de usuario Pagina 155