Rockwell-automation 284D ArmorStart - Safety Version - User Manual Manual de usuario descargar pdf (Pagina 146)

6-8 DeviceNet™ Commissioning

Setting the Motor FLA and

Overload Trip Class (Bulletin 280/

281)

The product should now be configured and communicating on the

network. The last step is to program the motor FLA setting

(parameter# 106) and overload trip class (parameter# 107). This can

be accomplished by using software such as RSNetWorx for

DeviceNet or another handheld DeviceNet tool.

Using the software, access the device parameters screen as shown

below. Notice that by default the motor FLA is set to the minimum

FLA setting for the device and the overload trip class is set to 10.

Select FLA setting (parameter #106) and enter a value that

corresponds to the FLA of the motor connected to the ArmorStart.

Make sure the single radio button is selected and then select

Download to Device.

Select Overload Class (parameter #107) and choose the overload trip

class to be used with the motor connected to the ArmorStart. The

ArmorStart can be set up for trip class 10, 15, or 20. Make sure the

Single radio button is selected and then select Download to Device.

The proper motor protection is now in place.

Figure 6.2 RSNetWorx Parameter Screen

1 2 ... 141 142 143 144 145 146 147 148 149 150 151 ... 319 320

Sin comentarios

Rockwell-automation 284D ArmorStart - Safety Version - User Manual Manual de usuario Pagina 146