Rockwell-automation 47C626 AutoMax Programming Executive V4.2 Manual de usuario descargar pdf (Pagina 104)

6Ć18

Step 6. Select OK to continue, or Cancel to return to the Rack

Configurator without copying the UDC drive.

Figure 6.9 Ć Copy Drive Dialog Box

6.16 Generating the Rack Configuration and

Drive Parameter Files

The Generate Configuration command from the Commands menu is

used to generate the rack configuration object file or, for UDC

modules in the rack, the drive parameter object file. When the

Generate Configuration command is selected, the following options

will be displayed: Generate Rack Configuration (either standard or

mapping I/O locations to memory for testing) and Generate Drive

Parameter Files. The next two sections describe these options.

The Transfer command from the On Line menu is used to load the

rack configuration object file into the AutoMax Processor. The same

command is also used to load the drive parameter object file to the

UDC. See section 14.3 for information about loading the drive

parameter object files.

6.16.1 Generating the Rack Configuration

The Generate Configuration command can be used to create the

object file (.CNF) for the rack configuration. The generated"

(compiled) rack configuration must be loaded onto the Processor(s)

in the rack before or at the same time application tasks are loaded.

See 14.3 for information about loading the rack configuration file(s).

See Appendix D for information about configuration file size limits.

When generating the rack configuration, you have the option of

mapping variables to common memory for testing. If you select this

option,

all

variables currently configured as I/O registers or I/O points

will be configured as common memory locations. This allows you to

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 277 278

Sin comentarios

Rockwell-automation 47C626 AutoMax Programming Executive V4.2 Manual de usuario Pagina 104