Rockwell-automation 47C626 AutoMax Programming Executive V4.2 Manual de usuario descargar pdf (Pagina 180)

15Ć2

15.1 Running an Individual Task

WARNING

THIS COMMAND OVERRIDES THE NORMAL STARTING SEQUENCE OF THE

APPLICATION TASKS, WHICH IS DETERMINED BY THE PRIORITY ASSIGNED

WHEN THEY ARE ADDED TO THE RACK. THE RUN ALL OPTION SHOULD

NORMALLY BE USED TO START TASKS. FAILURE TO OBSERVE THIS

PRECAUTION COULD RESULT IN BODILY INJURY.

Follow the directions below to put an individual task into run:

1. Select the task to be run from those displayed on the Online

menu. To select the task, use the up and down arrow keys to

move the >" pointer to the desired task.

2. T

ype the Enter" or <CR> key

. The selected task will be shown

in reverse video.

3. Type R" to put the task into run. The task Status" field on the

display will show that the task is in RUN.

Note that UDC tasks can

be run regardless of whether the PMI is

communicating with the UDC.

15.2 Running All Tasks in the Rack

To run all AutoMax and UDC tasks in the rack, including utility tasks,

using the procedure described in this section, all tasks in the rack

except utility tasks must be loaded in the rack. If this is not the case,

the

screen will display an error message

and no tasks will be put into

run.

Follow the directions below to put all tasks in the rack into run:

1. Do not select an individual task while at the Online menu.

Instead, type R" from the Online menu with no task selected.

This results in the display shown in figure 15.1.

1 2 ... 175 176 177 178 179 180 181 182 183 184 185 ... 277 278

Sin comentarios

Rockwell-automation 47C626 AutoMax Programming Executive V4.2 Manual de usuario Pagina 180