Rockwell-automation 47C626 AutoMax Programming Executive V4.2 Manual de usuario descargar pdf (Pagina 208)

18Ć22

18.6 Setting Up the UDC and PMI Meter Ports

If your system configuration incorporates an AutoMax Distributed

Power drive, the Monitor Set Up UDC/PMI menu allows you to

select variables to drive the four D/A output ports (labeled Meter

Ports") on each of the UDC modules and PMI Processors. The

analog signals output by these ports can be used to drive meters,

chart recorders, or other test instruments. Refer to the appropriate

DPS Configuration and Programming instruction manual for more

information on connecting equipment to the UDC and PMI meter

ports.

After the slot number of

a UDC module is entered, the user can enter

or modify setup information about the meter ports for the UDC

module or for either of the PMI Processors associated with that UDC

module. See figure 18.9 for the UDC Setup screen display.

Note that both the configuration file and the drive parameter file

(.POB file) must be downloaded to the UDC before you can set

up the UDC or PMI meter ports using Monitor.

Other Methods of Setting UP Meter Ports

PMI

meter ports can be set up during DPS parameter entry on on the

Monitor Setup UDC/PMI menu. UDC meter ports can be set up via

registers 1001-1017 in a UDC application task or on the Monitor

Setup

UDC/PMI menu. The setup information may be retained after a

Stop All or power cycle depending on the method used. See the

table below.

Table 18.1 Ć Meter Port Setup Retention

UDC Setup

via

Monitor

UDC Setup via

Application

Task (Reg.

1001Ć 1017)

PMI Setup

during

Parameter

Entry

PMI Setup

via

Monitor

Retained after

Stop All?

Yes Yes* Yes No**

Retained after

power cycle

No Yes* Yes No**

ă*Original task setup is retained.

**If

the PMI meter ports are set up using the parameter screens and then later set

up again using the Monitor menu, the setup in the parameter screens will still

be retained.

1 2 ... 203 204 205 206 207 208 209 210 211 212 213 ... 277 278

Comentarios a estos manuales

Sin comentarios

Rockwell-automation 47C626 AutoMax Programming Executive V4.2 Manual de usuario Pagina 208

Comentarios a estos manuales

Relacionado con productos y manuales para Equipo Rockwell-automation 47C626 AutoMax Programming Executive V4.2