Rockwell-automation 47C626 AutoMax Programming Executive V4.2 Manual de usuario descargar pdf (Pagina 44)

5Ć10

Figure 5.6 Ć T

ransferring a System Using Transfer





Use the following procedure to transfer systems using TransferĆPlus.

you are transferring to diskettes, you will be prompted for additional

diskettes, if needed. Diskettes can be formatted or, to save time, you

can use preĆformatted diskettes. Diskettes do not have to be blank.

Figure 5.7 illustrates the TransferĆPlus dialog box.

Step 1. Select the system(s) to be transferred from the systems

list.

Step 2. Select TransferĆPlus from the System menu. The

TransferĆPlus dialog box is displayed, with the selected

systems listed.

Step 3. Enter information for the following fields. Some fields

contain default entries. If you do not change these fields,

the defaults will be used.

Source/Destination Ć If you are transferring to or from

floppy diskettes, you must also select floppy drive A or B.

If you want to transfer to or from another AutoMax library,

select

More Options

and then enter the drive and AutoMax

library name.

Format

Ć Check this box if you want to format the diskettes

before transferring the files. You can also enter Format

Qualifiers (DOS FORMAT switches).

System(s) Ć The systems selected when the TransferĆPlus

command

was called are listed. Y

ou can edit this

list. If you

are transferring from diskette, or from another AutoMax

library, enter the systems to be transferred.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 277 278

Sin comentarios

Rockwell-automation 47C626 AutoMax Programming Executive V4.2 Manual de usuario Pagina 44