Rockwell-automation 6181F_P Series E Integrated Display Computers User Manual de usuario descargar pdf (Pagina 25)

Rockwell Automation Publication 6181P-UM002D-EN-P - February 2014 25

Installation Chapter 2

Mount the Display Computer in a Panel

Mounting clips secure the display computer to the panel. The number of clips

varies by model.

Follow these steps to mount the computer in a panel.

1. Remove power from the panel.

2. Verify that the panel surface around the area to be cut is clean and free of

be debris.

Cut an opening in the panel using the appropriate panel cutout dimensions.

4. Attach cables to the computer before installation if rear access to the

computer will be limited after installation. For where to attach cables, see

Connect Peripherals

on page 27.

AC power models: You might need to remove the AC retention clip

before installing the computers in a panel cutout. Reattach the clip after

installing the computer.

5. Make sure the sealing gasket is properly positioned on the computer.

This gasket forms a compression-type seal. Do not use sealing compounds.

6. Place the computer in the panel cutout.

7. Slide the mounting clips into the holes on the top, bottom, and sides of the

computer.

8. Hand-tighten the mounting clips around the bezel by following the

tightening sequence below.

Model Clips (qty.)

All with aluminum bezel and 1500P with stainless steel bezel 10

1700P with stainless steel bezel 12

Cat. No. Description

6189V-MCLPS3 Replacement mounting clips (14)

ATTENTION: Take precautions so metal cuttings do not enter

components already installed in panel to avoid personal injury or

damage to the panel components.

All Display Models with Aluminum Bezel

and 1500P Display with Stainless Steel Bezel

9110

827

1700P Display with Stainless Steel Bezel

9110

827

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 75 76

Sin comentarios

Rockwell-automation 6181F_P Series E Integrated Display Computers User Manual de usuario Pagina 25