Rockwell-automation 6181F_P Series E Integrated Display Computers User Manual de usuario descargar pdf (Pagina 50)

50 Rockwell Automation Publication 6181P-UM002D-EN-P - February 2014

Chapter 4 Component Replacement

13. Reinstall the rear cover as detailed in Reinstall the Cover on page 38.

14. Follow the steps for Post-configuration

on page 37.

Replace or Add

Memory Modules

The computers have two dual-channel DDR2 DIMM slots that support up to

4 GB maximum system memory.

Figure 13 - Memory Module Slots and Module Alignment

Memory Configuration Guidelines

Follow these guidelines when replacing or adding memory to the computers:

· Use only standard unbuffered memory modules that conform to both

PC2-3200 and SPD compliance industry standards.

· Use only DDR-II type memory modules.

· Use only memory modules with gold-plated contacts.

· Always handle a memory module by its edges.

If you intend to install Then

A compatible add-in card now Proceed to page 46 for instructions.

An add-in card later 1. Reinstall the rear cover.

2. Apply power to the computer.

ATTENTION: Some older Microsoft Windows operating systems limit the

maximum usable memory capacity to approximately 3 GB.

IMPORTANT

We recommend that you use only Allen-Bradley approved memory

modules. Refer to http://ab.rockwellautomation.com/Computers

for

qualified replacement parts and accessories.

Retaining Latch

Keyed Surface

of DIMM Slot

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 75 76

Sin comentarios

Rockwell-automation 6181F_P Series E Integrated Display Computers User Manual de usuario Pagina 50