Rockwell-automation 6181F_P Series E Integrated Display Computers User Manual de usuario descargar pdf (Pagina 42)

42 Rockwell Automation Publication 6181P-UM002D-EN-P - February 2014

Chapter 4 Component Replacement

Drive Precautions

Follow these precautions when working with a drive.

• Do not touch internal components.

• Always handle the drive by its frame.

• Never remove or install a drive with the power on.

• Store the drive in an antistatic bag when it is not installed.

Replace a Drive

The procedures for replacing a drive (HDD or SSD) are different for the

computer models.

Replace a Performance and Non-display Computer Drive

The drive (HDD or SSD) in performance and non-display computers is on the

right side of the computer.

Follow these steps to replace the drive.

1. Read and follow Drive Precautions

on page 42 before performing any drive

removal.

2. Follow the steps for Pre-configuration

on page 36.

3. Remove the one screw that secures the drive assembly (A).

4. Loosen the screw to release the carrier lever (B).

5. Extend the carrier lever (C), then use it to slide the assembly out of the

drive bay (D).

6. Remove the four screws that secure the drive to its carrier (E).

7. Lift the cable connector end of the drive (F) and disconnect the power and

data cables (G).

8. Remove the default drive from its carrier

IMPORTANT

Back up or clone your computer before replacing a drive.

SHOCK HAZARD: Electrostatic discharge (ESD) can damage the computer and

components. Read and follow Electrostatic Discharge Precautions

on page 36

before removing a drive.

Failure to follow proper safety precautions can result in severe electrical shock to

an individual or ESD damage to the computer and its components.

ATTENTION: Mechanical shock can damage a drive. Do not drop or bump the

drive.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 75 76

Sin comentarios

Rockwell-automation 6181F_P Series E Integrated Display Computers User Manual de usuario Pagina 42