Rockwell-automation AutoMax ControlNet Communication Interface Module Manual de usuario descargar pdf (Pagina 38)

Page 38 AutoMax ControlNet Module

Publication number DSMBCN-UM001B-EN-P February 2003

General

Status,

hex

Extended

Status,

hex

Explanation

15 n/a Too much data was received.

25 0114 Either the Vendor Id or the Product Code in the key

segment did not match the device. Used if the Key

Segment was contained in the path.

25 0115 Product Type in the key segment did not match the

device. Used if the Key Segment was contained in

the path.

25 0116 Major or Minor Revision information in the key

segment did not match the device. Used if the Key

Segment was contained in the path.

26 n/a Invalid path size

D0 01 Connection is closed or stopped

D0 02 Connection open is pending.

(Target connection) Nothing is talking to this

connection.

D0 03 Connection close is pending

Figure 5 Connection Status Values

Operating Status

The following registers contain information about the operation of the

MBCN.

Number of Instances

This includes both originator-to-target (O=>T) and target-to-originator

(T=>O) connections.

Overall Status

If bit 0 is set, all I/O and scheduled consume and scanner (originator)

connections are operating with no errors.

If bit 8 is set, all scheduled produced (target) connections are operating

with no errors.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 79 80

Sin comentarios

Rockwell-automation AutoMax ControlNet Communication Interface Module Manual de usuario Pagina 38